Please see below for a link to the Access200w™ cable specification drawings.
The pdf titled "1000-1740 REV-B.PDF" shows the wire layout of the Ethernet cable that is pre-attached to the Access200w™. The weatherized connector is also already connected to the device, but this layout informs the installer of how to connect the second weatherized connector to their existing cable.
The pdf titled "1000-1741 REV-B.PDF" shows the wire layout of the Wiegand wires that are pre-attached to the Access200w™. The wires are already connected to the device, but this layout informs the installer of how to connect to their existing cable. The layout is the same for the panel and reader wires, however only the panel wire includes the relay connections on wires 7 and 8.
The jpg titled "A200W_Heat_Sink_Cabling.png" shows the back of the Access200w™. In this photo, the words "Power", "Panel", "Reader", and "Ethernet" are shown. These holes are labelled with the purpose of the wire that extends from each hole. During installation, ensure that each wire is connected for its intended purpose.
If you have any questions, please contact Princeton Identity Support: support@princetonidentity.com.